Not a Lexis Advance subscriber? Try it out for free.


Babst Calland: EPA Issues Advisory Concerning Design of Newly Constructed Natural Gas Processing Plants

By Jonathan E. Dan

The U.S. Environmental Protection Agency (EPA) recently issued an Interim Chemical Accident Prevention Advisory concerning the design of liquefied petroleum gas (LPG) installations at natural gas processing plants.  EPA has found that some existing plants were constructed in accordance with National Fire Protection Association 58, Liquefied Petroleum Gas Code (NFPA 58).  EPA notes in the advisory announcement that NFPA 58 does not apply to natural gas processing plants and that more specific industry standards would apply in determining compliance with the requirements of the risk management provisions of Section 112(r) of the Clean Air Act, and the Chemical Accident Prevention Provisions of 40 CFR Part 68.  EPA has suggested that American Petroleum Institute 2510, Design and Construction of Liquefied Petroleum Gas (LPG) Installations (API 2510) and its companion document API 2510A, Fire Protection Considerations for the Design and Operation of LPG Storage Facilities (API 2510A), are more widely recognized standards for the design of LPG installations at natural gas power plants.  EPA is accepting comments on this interim advisory until July 31, 2014.

Copyright 2014 • Babst, Calland, Clements and Zomnir, P.C. • Two Gateway Center, Pittsburgh, PA 15222 • 412-394-5400 • Administrative Watch is privately distributed by Babst, Calland, Clements and Zomnir, P.C., for the general information of its clients, friends and readers. It is not designed to be, nor should it be considered or used as, the sole source of analyzing and resolving legal problems. If you have, or think you may have, a legal problem or issue relating to any of the matters discussed in the Administrative Watch, consult legal counsel.

For more information about LexisNexis products and solutions, connect with us through our corporate site.